If you want to create a list of thematic codes without any hierarchy you must always click on the Code System header code at the top of the list before opening the New code dialog and then your list will appear as equals at the highest level of the code system. This may not be the effect that you want, but it demonstrates how a new code will always be made a sub-code of something. If you leave the code you have just created highlighted in the Code System window and create another thematic code, say “Fear”, it will appear as a sub-code of the first code (“Angry”). See the new code appear and be highlighted in the Code System window just beneath the code that was highlighted when you started the routine (the “Code System” header if you followed the instructions above correctly). Used words like cross, furious, angry”), and finish by clicking on the “OK” button. To make this a thematic code, simply type the code name that you want to use (say “Angry”) into the first field, accept the suggested colour for now, and type the beginnings of a code definition into the Code memo field (say “Expressed anger. All of these elements can be edited and changed at any stage so there is a lot of flexibility and no decision that you take closes-off later options.įigure 7.1.1 – Adding a new code to the Code System The “New code” dialog has 3 elements, a field for the code name, an option to select a colour for this code, and a field to store a memo for the code. Right-click on the highlighted code and select “New code” from the context menuĪll of these have the same effect, and open the “New code” dialog as shown in Figure 7.1.1.Click on the “New code” icon in the Code System toolbar (2 nd icon in Figure 7.1.1).Then you have at least 4 equivalent ways of opening the “New code” dialog: To create a new code, click on the highest level code in the Code System window (the code called “Code System”) as shown highlighted in Figure 7.1.1, below. But nothing is permanently fixed, both headers and codes can be moved around the Code System as may be required at any stage. The program will make an assumption over which is being created depending on the location of the cursor when the routine is started. The same routine is used to create a single thematic code as is used to create the header of a group of codes. This work is mainly carried out in the Code System window, usually located in the bottom left corner of the MAXQDA11 screen. Where you have some ideas for codes that you expect to be useful in a project, you can create these at an early stage and then start to apply them to the data. Codes can be created or added at any time in MAXQDA11 with simple intuitive procedures.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |